​

​

​

​

Nowadays As an essential part of new built houses is central vacuum cleaners.

It seems most of builders just run piping end pipe till garage and then they leave it for finishing up by home owners.

We strongly recommended to do all stages by same low voltage (or central vacuum) contractors.  

Regarding our mission to do a fully low voltage services we design, supply, piping, installation, wiring, run central unit and inlets.

​

Tips for central vacuum installation :

The project can be completed by a quality installer and most systems take one or two days to install.

Good planning will ensure the project is done right and the vacuum system works properly.

• Determine the size of your home including all locations that will require the central vacuum.

• Choose the proper vacuum system according to the square footage.

• Determine the power unit location

• The central vacuum system motor is louder than a portable vacuum; install in a location where the sound will not be disruptive such as the garage or the basement.

• Preferably needs a dedicated 15 or 20 amp circuit and plenty of room for air to circulate on all sides of the unit.

•  Determine the amount of wall inlets as well as their locations:

• For most homes, install one inlet per 600 sq. ft.

• For retrofits, install the inlet valves within 6' of an electric receptacle so that accessory power cords can be used if needed.

• Plan for all inlets to be located within interior walls to avoid dealing with insulation in exterior walls.

• Good locations for inlets are centrally located such as in hallways, closet walls, or doorways.

• Do not place inlet valves behind doors and furniture.

• Floor inlet valves are sometimes a good option.

• When laying out the valve locations, make sure the entire home can be reached with a standard 30' hose.

• Grab the handle and double-check the hose’s reach before completing the installation.

• Determine the layout and location of pipes and fittings as well as the necessary amount of each. Count approximately 16' of piping per inlet.

​

​

​

​